这些小活动你都参加了吗?快来围观一下吧!>>
电子产品世界 » 论坛首页 » 嵌入式开发 » MCU » 关于VxWorks调试中出现的问题

共1条 1/1 1 跳转至

关于VxWorks调试中出现的问题

菜鸟
2007-12-22 10:15:53     打赏
配置好target server后,点击launch,出现了错误对话框,
 
there was a problem sending licensing information over your network.
cause:the program \"ckserve\" isn\'t running on the server or your computer.
suggestion: in order to run this program over a network,ckserve must be running on the network server.
if your are running windows NT. Ckserve must be running on the server or your computer even if you don\'t wish to share licensec over a network. reinstalling this program should install the ckserve program.
请问ckserve是什么?怎么解决?

我的环境是Tornado2.0+XP,目标机是PC104(486)



关键词: 关于     VxWorks     调试     出现     问题    

共1条 1/1 1 跳转至

回复

匿名不能发帖!请先 [ 登陆 注册 ]