EEPW论坛

核心底板上留有JTAG口

试试看

1.Erase Full Chip

2.Reset and Run

然后下面的你Add你的STM32F1这个设备进去

然后Add  STM32F10x........这个设备进去。如下图所示:

然后就可以写入程序进行仿真了。

Load "D:\\keil472-a\\STM32F10x_StdPeriph_Lib_V3.5.0\\STM32F10x_StdPeriph_Lib_V3.5.0\\Project\\STM32F10x_StdPeriph_Template\\MDK-ARM\\STM32100E-EVAL\\STM32100E-EVAL.axf" 
Set JLink Project File to "D:\keil472-a\STM32F10x_StdPeriph_Lib_V3.5.0\STM32F10x_StdPeriph_Lib_V3.5.0\Project\STM32F10x_StdPeriph_Template\MDK-ARM\JLinkSettings.ini"
* JLink Info: Device "STM32F102RB" selected (128 KB flash, 16 KB RAM).
 
JLink info:
------------
DLL: V4.70 , compiled May  7 2013 21:38:06
Firmware: J-Link ARM V8 compiled Nov 14 2012 22:34:52
Hardware: V8.00
S/N : 286370559 
Feature(s) : RDI,FlashDL,FlashBP,JFlash 
 
* JLink Info: Found SWD-DP with ID 0x1BA01477
* JLink Info: Found SWD-DP with ID 0x1BA01477
* JLink Info: TPIU fitted.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
* JLink Info: Found Cortex-M3 r1p1, Little endian.
ROMTableAddr = 0xE00FF003
 
Target info:
------------
Device: STM32F102RB
VTarget = 3.254V
State of Pins: 
TCK: 0, TDI: 0, TDO: 0, TMS: 1, TRES: 1, TRST: 1
Hardware-Breakpoints: 6
Software-Breakpoints: 8192
Watchpoints:          4
JTAG speed: 4000 kHz
 
Full Chip Erase Done.
Programming Done.
Verify OK.
Application running ...

 最后，谢谢各位大牛们耐心的指导。