【应用手册】AN 571: Implementing the SERDES Framer Interface Level 5 (SFI-5.1) Protocol in Stratix IV Devices
This application note describes how to implement an SFI-5.1 interface using Altera’s
40 nm Stratix® IV GX and Stratix IV GT devices.
The SFI-5.1 is a chip-to-chip or chip-to-module protocol that targets 40 Gbps
applications. The protocol allows up to 25% overhead for forward error correction
(FEC) code for a maximum throughput of 50 Gbps.
Both Stratix IV GX and Stratix IV GT devices support SFI-5.1 interfaces using
high-speed CDR-based transceivers.
Figure 1 shows a typical OC-768 packet over SONET (POS) line card application that
uses a Stratix IV GX device to implement an OC-768 framer and FEC processor. The
line-side interface to the 40G optical module uses SFI-5.1, while the system-side
interface to the packet processor uses either the industry-standard Interlaken or the
proprietary SerialLite II protocol.an571.pdf
共1条
1/1 1 跳转至页
【应用手册】AN 571: Implementing the SERDES Framer Interface Level 5 (SFI-5.1) Protoco
共1条
1/1 1 跳转至页
回复
有奖活动 | |
---|---|
【EEPW电子工程师创研计划】技术变现通道已开启~ | |
发原创文章 【每月瓜分千元赏金 凭实力攒钱买好礼~】 | |
【EEPW在线】E起听工程师的声音! | |
“我踩过的那些坑”主题活动——第001期 | |
高校联络员开始招募啦!有惊喜!! | |
【工程师专属福利】每天30秒,积分轻松拿!EEPW宠粉打卡计划启动! | |
送您一块开发板,2025年“我要开发板活动”又开始了! | |
打赏了!打赏了!打赏了! |
打赏帖 | |
---|---|
【我踩过的那些坑】STM32的硬件通讯调试过程的“坑”被打赏50分 | |
【我踩过的那些坑】晶振使用的问题被打赏100分 | |
【我踩过的那些坑】电感选型错误导致的处理器连接不上被打赏50分 | |
【我踩过的那些坑】工作那些年踩过的记忆深刻的坑被打赏10分 | |
【我踩过的那些坑】DRC使用位置错误导致的问题被打赏100分 | |
我踩过的那些坑之混合OTL功放与落地音箱被打赏50分 | |
汽车电子中巡航控制系统的使用被打赏10分 | |
【我踩过的那些坑】工作那些年踩过的记忆深刻的坑被打赏100分 | |
分享汽车电子中巡航控制系统知识被打赏10分 | |
分享安全气囊系统的检修注意事项被打赏10分 |